Common Specifications & Procedures
EDGE/MKX COMMON SPECIFICATIONS & PROCEDURES
| System | Specifications/Procedures | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 258 Ft. Lbs. (350 N.m) | ||
| Rear | |||
| Inner | 203 Ft. Lbs. (275 N.m) | ||
| Outer | 129 Ft. Lbs. (175 N.m) | ||
| Battery | GENERAL SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Front Disc Brakes w/Torque | SPECIFICATIONS | ||
| Rear Disc Brakes w/Torque | SPECIFICATIONS | ||
| Charging | |||
| Generator w/Torque | SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | BELT TENSIONER | ||
| Belt Routing | ACCESSORY DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | GENERAL SPECIFICATIONS | ||
| Radiator Cap Pressure | 13-18 psi (89-124 kPa) | ||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | COOLANT PUMP | ||
| Engine Mechanical | |||
| 3.5L | |||
| Compression | COMPRESSION TEST | ||
| Oil Pressure (minimum at 1,500 RPM with engine at normal operating temperature.) | 30 psi | ||
| Overhaul | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 3.7L | |||
| Compression | COMPRESSION TEST | ||
| Oil Pressure (minimum at 1,500 RPM with engine at normal operating temperature.) | 30 psi | ||
| Overhaul | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | 59 Ft. Lbs. (80 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Located in fuel tank as part of Fuel Pump Module. | ||
| Fuel Filter R & I | FUEL PUMP MODULE | ||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification | FUEL SYSTEM PRESSURE SPECIFICATIONS | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Routing) | Engine is equipped with Coil-on-plug ignition. | ||
| Spark Plugs | |||
| Type | Motorcraft CYFS12F-5 | ||
| Gap | .049-.053 In. (1.25-1.35 mm) | ||
| Torque | 133 In. Lbs. (15 N.m) | ||
| Starting | |||
| Starter | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||