Removal and Installation
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
Edge
NOTE:
If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.
- Upload the GPSM configuration information to the scan tool by following the scan tool on screen instructions.
- Remove the Instrument Panel Cluster (IPC). For additional information, refer to INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES .
- Release the clip and remove the GPSM
.
- Disconnect the electrical connector.
MKX
NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation. - Upload the GPSM configuration information to the scan tool by following the scan tool on screen instructions.
- Remove the LH IPC top cover. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Release the clip and remove the GPSM
.
- Disconnect the electrical connector.
All vehicles
- To install, reverse the removal procedure.
- Download the GPSM configuration information from the scan tool to the new GPSM following the scan tool on screen instructions.