Cruise-Control Module (C-CM): Installation

Bracket 

1. Install the 4 bolts and the C-CM  bracket assembly.
   • Tighten the bolts to 8 Nm (71 lb-in).

   C-CM or bracket 

2. NOTE: If a plastic grommet breaks while the C-CM  is being installed, a new grommet should be installed.

   Firmly apply pressure to the C-CM  so that it seats completely in the grommets.

3. Once the C-CM  is installed, pull the C-CM  to confirm that all 3 ball studs are fully seated in the grommets.
4. Connect the C-CM  connector.
5. Vertically and horizontally align the C-CM  . For additional information, refer to CRUISE CONTROL MODULE (C-CM) (WITH SENSOR) ADJUSTMENT  in this service information.
6. Install the front bumper cover. For additional information, refer to BUMPERS .