Audio Systems With Touchscreen: Notes
WARNING: This page is about a different car, the 2014 Lincoln MKX and 2014 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
-
NOTE: If the Audio Front Control Module (ACM) is completely inoperative (does not power up), obtain the ACM part number using the part number decal on the ACM .
Turn the ACM on.
- Operate the audio system in radio tuner (AM/FM) mode.
- Press and hold the EJECT button, and within 1 second, press the SEEK UP button until the speaker walk-around test begins.
- The display indicates each speaker as it is tested.
-
NOTE: If the speaker walk-around test is the only test required, this procedure can be stopped after Step 3 by turning the ACM off, or by selecting Exit using the touchscreen menu.
Once the speaker walk-around test is complete, the following information is available through the "BEZEL DIAGNOSTICS" menu using the touchscreen menus:
NOTE: The AHU Diagnostics refers to the ACM and EFP Diagnostics refers to the Front Controls Interface Module (FCIM).Menu Sub-Menu APIM Diagnostics Part Numbers Software Versions Configuration Status GPS Information Tones Test Rear Tones Test Touch Screen Calibration Touch Screen Activation Test Display Test Pattern RGB Pixel Test Exit Diagnostics AHU Diagnostics AHU Part Numbers/Sirius Electronic Serial Number (ESN) Radio Signal Strength Exit Diagnostics Menu Sub-Menu DSP Diagnostics DSP Part Numbers Speaker Walk-Around Test Exit Diagnostics Menu Sub-Menu EFP Diagnostics EFP Part Numbers Exit Diagnostics - To exit the self-diagnostic mode, press the "Exit Diagnostics" selection from the "BEZEL DIAGNOSTICS" menu.