Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Ball joint | 63 | 46 | - | ||
| Black transaxle case bolt(1) | - | - | - | ||
| Clutch hydraulic tube bracket bolt | 2.5 | - | 22 | ||
| Crossmember bolts | 115 | 85 | - | ||
| Drain plug | 35 | 26 | - | ||
| Fill level inspection plug | 35 | 26 | - | ||
| Final drive gear bolts(1) | - | - | - | ||
| Intermediate shaft nuts | 27 | 20 | - | ||
| LH transaxle support insulator bolts | 48 | 35 | - | ||
| LH transaxle support insulator bracket nuts | 40 | 30 | - | ||
| LH transaxle support insulator through bolt | 103 | 76 | - | ||
| Mainshaft bearing retainer bolt | 7 | - | 62 | ||
| Reduction gear bolts(1) | - | - | - | ||
| Reverse lever bracket bolts | 14 | - | 124 | ||
| RH engine support bolt | 90 | 66 | - | ||
| Shift assembly bolts | 7 | - | 62 | ||
| Shift cable bracket bolts | 22 | 16 | - | ||
| Shift check bolt | 24 | 18 | - | ||
| Stabilizer bar link | 55 | 41 | - | ||
| Standard (gold) transaxle case bolts(1) | - | - | - | ||
| Stopper bolt | 28 | 21 | - | ||
| Tie-rod end | 55 | 41 | - | ||
| Transaxle fill plug | 35 | 26 | - | ||
| Transaxle front support insulator bolts | 90 | 66 | - | ||
| Transaxle front support insulator bracket bolts | 48 | 35 | - | ||
| Transaxle front support insulator through bolt | 115 | 85 | - | ||
| Transaxle front-to-aft crossmember bolts | 90 | 66 | - | ||
| Transaxle front-to-aft crossmember nut | 175 | 129 | - | ||
| Transaxle rear support insulator bolt | 80 | 59 | - | ||
| Transaxle rear support insulator bracket bolts | 48 | 35 | - | ||
| Transaxle rear support insulator nuts | 80 | 59 | - | ||
| Transaxle rear support insulator through bolt | 115 | 85 | - | ||
| Transaxle-to-engine bolts | 47 | 35 | - | ||
| Wiring harness bracket nuts | 12 | - | 106 | ||
|
|||||