Common Specifications & Procedures
EXPEDITION, EXPEDITION EL, NAVIGATOR, & NAVIGATOR L COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front Hub Nut | 20 Ft. Lbs. (27 Nm) | ||
| Rear Hub Nut | 184 Ft. Lbs. (250 Nm) | ||
| Battery | BATTERY AND CABLES | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Disc Brakes | |||
| Front | GENERAL SPECIFICATIONS | ||
| Rear | GENERAL SPECIFICATIONS | ||
| Torque | |||
| Front | TORQUE SPECIFICATIONS | ||
| Rear | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator w/Torque | SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | ACCESSORY DRIVE BELT TENSIONER | ||
| Belt Routing | ACCESSORY DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | GENERAL SPECIFICATIONS | ||
| Radiator Cap Pressure | 16 psi (110 kPa) | ||
| Thermostat R & I | THERMOSTAT AND THERMOSTAT HOUSING | ||
| Water Pump R & I | COOLANT PUMP | ||
| Engine Mechanical | |||
| 5.4L (3V) | |||
| Compression | COMPRESSION TEST -- COMPRESSION GAUGE CHECK | ||
| Oil Pressure (@ 2,000 RPM, engine at normal operating temperature) | 40-75 psi (275-517 kPa) | ||
| Overhaul | GENERAL SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | 59 Ft. Lbs. (80 Nm) | ||
| Fuel System | |||
| Fuel Filter Location | Located in front of the fuel tank | ||
| Fuel Filter R & I | FUEL PUMP MODULE | ||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification | GENERAL SPECIFICATIONS | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST | ||
| Ignition | |||
| Ignition Cable Resistance | Engine has coil-on-plug ignition. | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Spark Plugs | |||
| 5.4L (3V) | |||
| Type | Motorcraft HJFS-24FP | ||
| Gap | 0.039-0.043 In. (1.05 +/- 0.05 mm) | ||
| Torque | 9 Ft. Lbs. (12 N.m) | ||
| Starting | |||
| Starter w/Torque | SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| With rear coil spring suspension | GENERAL SPECIFICATIONS | ||
| With rear air suspension | ALIGNMENT SPECIFICATIONS VEHICLES WITH REAR AIR SUSPENSION | ||
| Torque | |||
| RWD vehicles | TORQUE SPECIFICATIONS | ||
| 4WD vehicles | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 150 Ft. Lbs. (204 N.m) | ||