Pinpoint Test

INSPECT THE FRONT BUMPER COVER FOR DAMAGE
1. With the vehicle in NEUTRAL, position it on a hoist. REFER to LIFTING POINTS .
2. Inspect the front and back of the front bumper cover for damage.
  - Is the front bumper cover damaged?
  1. Yes: REPAIR or INSTALL a new front bumper cover as necessary. If installing a new front bumper cover, REFER to BUMPER COVER - FRONT .
  2. No: GO to 2 on page 2.
INSPECT THE Cruise-Control Module (C-CM) AND FRONT BUMPER COVER FOR DEBRIS, MOISTURE, SNOW OR ICE
1. Inspect for debris, moisture, snow or ice on the front and back of the front bumper cover and sensor.
  - Is the Cruise-Control Module (C-CM) obstructed or blocked?
  1. Yes: CLEAN the front bumper cover and radar sensor portion as necessary.
  2. No: GO to 3 on page 2.
INSPECT THE Cruise-Control Module (C-CM) BRACKET FOR CORRECT MOUNTING
1. Inspect the Cruise-Control Module (C-CM) for loose mounting or damage at the 3 mounting points.
  - Is the Cruise-Control Module (C-CM) bracket loose or damaged?
  1. Yes: Correctly INSTALL the bracket or INSTALL new grommets as necessary. ALIGN the sensor. REFER to CRUISE CONTROL MODULE (C-CM) (WITH SENSOR) ADJUSTMENT .
  2. No: GO to 4 on page 2.
CARRY OUT THE VERTICAL AND HORIZONTAL ALIGNMENT
1. Carry out the alignment procedures for the Cruise-Control Module (C-CM). REFER to CRUISE CONTROL MODULE (CCM) (WITH SENSOR) ADJUSTMENT
  - Is the concern still present?
  1. Yes: INSTALL a new Cruise-Control Module (C-CM). REFER to CRUISE CONTROL MODULE (C-CM) .
  2. No: The system is operating correctly. The condition was caused by misalignment.