Front Control/Display Interface Module (FCDIM) DTC Chart
WARNING: This page is about a different car, the 2012 Ford Fiesta. However, it is still accessible from the selected car via links, so may be relevant.
FRONT CONTROL/DISPLAY INTERFACE MODULE (FCDIM)
| DTC | Description | Action |
|---|---|---|
| B10BD:11 | Multifunctional Switch: Circuit Short to Ground | GO to Pinpoint Test D . |
| B10BD:13 | Multifunctional Switch: Circuit Open | GO to Pinpoint Test D . |
| B10BD:23 | Multifunctional Switch: Signal Stuck Low | GO to Pinpoint Test D . |
| U0010:88 | Medium Speed CAN Communication Bus: Bus Off | REFER to MODULE COMMUNICATIONS NETWORK . |
| U0074:88 | Control Module Communication Bus "B" Off: Bus Off | REFER to MODULE COMMUNICATIONS NETWORK . |
| U1A00:00 | Private Communication Network: No Sub Type Information | GO to Pinpoint Test Y . |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test P . |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test U . |
| U0193:00 | Lost Communication With "Digital Audio Control Module A": No Sub Type Information | GO to Pinpoint Test X . |
| U0423:68 | Invalid Data Received From Instrument Panel Cluster Control Module: Event Information | RETRIEVE and FOLLOW other DTCs present in the FCDIM or IPC. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | PROGRAM the FCDIM. REFER to the Programmable Module Installation (PMI) procedure in MODULE CONFIGURATION . TEST the system for normal operation. |
| U3000:00 | Control Module: No Sub Type Information | INSTALL a new FCDIM. REFER to Front Controls/Display Interface Module (FCDIM) . TEST the system for normal operation. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AE . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AF . |
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2-character DTC status code suffix to assist in determining DTC history.