Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: It is not necessary to remove the Audio Front Control Module (ACM) to retrieve the part number. For additional information, refer to AUDIO CONTROL MODULE (ACM) SELF-DIAGNOSTIC MODE .

All vehicles

NOTE: Module configuration is required when a new ACM is being installed.

Upload the ACM configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION .
Vehicles without navigation
Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
Vehicles with navigation
Remove the Front Display Interface Module (FDIM). For additional information, refer to FRONT DISPLAY INTERFACE MODULE (FDIM) .
All vehicles
Remove the 4 screws and the ACM.
- Disconnect the electrical connectors and the antenna lead-in cable.
To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to MODULE CONFIGURATION .