LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Flex SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 1906 (Information System And Entertainment System) >> Removal And Installation >> Front Display Interface Module (FDIM) >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2012 Ford Flex. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Vehicles without navigation require Programmable Module Installation (PMI) when a new module is being installed. For vehicles with navigation, the Front Display Interface Module (FDIM) is not a stand-alone module.
  1. For vehicles without navigation, upload the FDIM configuration information to the scan tool. For additional information, refer to PMI in MODULE CONFIGURATION .
  2. Remove the center instrument panel finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
    3. NOTE: For vehicles with navigation, make sure not to bend the FDIM video feed cable when removing the FDIM or the cable may be damaged.
  3. Remove the 4 screws and the FDIM.
    • Disconnect the electrical connector.
  4. To install, reverse the removal procedure.
    • For vehicles without navigation, download the configuration information to the FDIM. For additional information, refer to PMI in MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals