Cruise-Control Module (C-CM): Installation
WARNING: This page is about a different car, the 2011 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
Bracket
- Install the 3 bolts and the C-CM bracket assembly.
- Tighten the bolts to 9 Nm (80 lb-in).
C-CM or bracket
NOTE: The vertical and horizontal alignment procedures need to be carried out to align the sensor. - Firmly apply pressure to the C-CM so that it seats completely in the grommets.
- Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.
- Connect the C-CM connector.
- Do not install the front bumper cover until the alignment procedures are carried out.
- Vertically and horizontally align the C-CM. For additional information, refer to CRUISE CONTROL MODULE (C-CM) (WITH SENSOR) ADJUSTMENT .
NOTE:
If one plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.