LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Fusion S, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Electronically Controlled Continuously Variable Transmission (ECVT)) >> In-Vehicle Repair >> Transmission Range (TR) Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Range (TR) Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position TR sensor on the manual shaft, align the 2 TR sensor bolt holes and install the 2 bolts.
    • Tighten to 5 Nm (44 lb-in).
    Fig 1: Locating TR Sensor Mounting Bolts
    G07786166Courtesy of FORD MOTOR CO.
  2. Install the manual control lever and the nut.
    • Tighten to 12 Nm (106 lb-in).
    Fig 2: Locating Manual Control Lever Mounting Nut
    G06275509Courtesy of FORD MOTOR CO.
  3. Connect the TR sensor electrical connector.
    Fig 3: Locating TR Sensor Electrical Connector
    G06275505Courtesy of FORD MOTOR CO.
  4. Adjust the selector lever cable. For additional information, refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS - FUSION HYBRID, MILAN HYBRID & MKZ HYBRID article. Connect the selector lever cable end.
    Fig 4: Locating Selector Lever Cable
    G06275504Courtesy of FORD MOTOR CO.
  5. Install the underbody cover and 7 screws.
Fig 5: Locating Underbody Cover Mounting Screws
G06257240Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals