Body Control Module B (BCM-B) DTC Chart
WARNING: This page is about a different car, the 2010 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This module utilizes a 5-character DTC followed by a 2-character failure-type code. The failure-type code provides information about specific fault conditions such as opens, or shorts to ground. Continuous memory DTCs have an additional 2- character DTC status code suffix to assist in determining DTC history.
DTC CHART
| DTC | Description | Action |
|---|---|---|
| B109F:08 | Intrusion Sensor Module: Bus Signal/Message Failures | REFER to ANTI-THEFT - PERIMETER . |
| B109F:49 | Intrusion Sensor Module: Internal Electronic Failure | REFER to ANTI-THEFT - PERIMETER . |
| B109F:55 | Intrusion Sensor Module: Not Configured | REFER to MODULE CONFIGURATION . |
| B109F:97 | Intrusion Sensor Module: Component Or System Operation Obstructed Or Blocked | REFER to ANTI-THEFT - PERIMETER . |
| P2533:14 | Ignition Switch Run/Start Position Circuit: Circuit Short To Ground Or Open | GO to PINPOINT TEST I . |
| U0140:87 | Lost Communication With Body Control Module: Missing Message | GO to PINPOINT TEST G . |
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC ) Control Module: Missing Message | GO to PINPOINT TEST H . |
| U0422:68 | Invalid Data Received From Body Control Module: Event Information | GO to PINPOINT TEST G . |
| U0423:68 | Invalid Data Received from Instrument Panel Cluster Control Module: Event Information | GO to PINPOINT TEST H . |
| U1000:00 | Solid State Driver Protection Actived - Driver Disabled: No Sub Type Information | GO to PINPOINT TEST E . |
| U2100:55 | Initial Configuration Not Complete: Not Configured | REFER to MODULE CONFIGURATION . |
| U3000:49 | Control Module: Internal Electronic Failure | GO to PINPOINT TEST E . |
| U3003:62 | Battery Voltage: Signal Compare Failure | GO to PINPOINT TEST F . |
| All other DTCs | - | REFER to the DIAGNOSTIC TROUBLE CODE (DTC) CHART . |