LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Ranger 2D Pickup, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the 2 nuts.
    • Tighten to 10 Nm (89 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Position the ground wire terminals and install the stud bolt.
    • Tighten to 10 Nm (89 lb-in).
  4. Install the PCM wiring harness retainer nut.
    • Tighten to 10 Nm (89 lb-in).
    5. NOTE: If a new PCM is installed, the parameters must be reset in both the PCM and the instrument cluster module or the vehicle will experience a Passive Anti-Theft System (PATS) no-start. This will occur even if the vehicle is not equipped with PATS. PATS vehicles and non-PATS vehicles have parameters in the instrument cluster module and the PCM and they both must be reset whenever a new PCM is installed. For additional information on PATS, refer to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
  5. Restore the module configurations for the instrument cluster module and the PCM. Carry out the module configuration restore steps of the Programmable Module Installation procedure. For additional information, refer to MODULE CONFIGURATION SYSTEM article.
scientia non olet · About LEMON Manuals