Common Specifications & Procedures
RANGER COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 184 Ft. Lbs. (250 N.m) | ||
| Battery | SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF BRAKE SYSTEM BLEEDING |
||
| Front Disc Brakes | |||
| Specifications w/Torque | SPECIFICATIONS | ||
| Rear Disc Brakes | |||
| Specifications w/Torque | SPECIFICATIONS | ||
| Charging | |||
| Generator | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | ACCESSORY DRIVE BELT TENSIONER -- 2.3L or ACCESSORY DRIVE BELT TENSIONER -- 4.0L | ||
| Belt Routing | See appropriate graphic under ACCESSORY DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | |||
| 2.3L | 16 psi (110 kPa) maximum | ||
| 4.0L SOHC | Use individual readings listed on the pressure relief cap | ||
| Thermostat R & I | |||
| 2.3L | THERMOSTAT HOUSING -- 2.3L | ||
| 4.0L SOHC | THERMOSTAT -- 4.0L SOHC | ||
| Water Pump R & I | |||
| 2.3L | COOLANT PUMP -- 2.3L | ||
| 4.0L SOHC | COOLANT PUMP -- 4.0L SOHC | ||
| Engine Mechanical | |||
| 2.3L | |||
| Compression | COMPRESSION TEST -- COMPRESSION GAUGE CHECK | ||
| Oil Pressure (Hot @ 2000 RPM) | 29-39 psi (200-268 kPa) | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| 4.0L SOHC | |||
| Compression | COMPRESSION TEST -- COMPRESSION GAUGE CHECK | ||
| Oil Pressure (Minimum Oil Pressure At 2, 000 RPM, Engine At Normal Operating Temperature) | 15 psi (103 kPa) | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Fluid Specifications | See FLUID under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | |||
| 2.3L | |||
| Manual Transmission | FLYWHEEL | ||
| Automatic Transmission | FLEXPLATE | ||
| 4.0L SOHC | |||
| Manual Transmission | FLYWHEEL | ||
| Automatic Transmission | FLEXPLATE | ||
| Fuel System | |||
| Fuel Filter Location | Under vehicle, just forward of left door along frame rail, mounted in bracket. | ||
| Fuel Filter R & I | FUEL FILTER | ||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification | 60-65 psi (414-448 kPa) | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | |||
| 2.3L | SPARK PLUG WIRES | ||
| 4.0L SOHC | SPARK PLUG WIRES | ||
| Ignition Wires (Routing) | |||
| 2.3L | COIL TERMINAL-TO-CYLINDER RELATIONSHIP | ||
| 4.0L SOHC | COIL TERMINAL-TO-CYLINDER RELATIONSHIP | ||
| Spark Plugs | |||
| 2.3L | |||
| Type | Motorcraft AGSF-32FEC | ||
| Gap | .049-.053 In. (1.25-1.35 mm) | ||
| Torque | 9 Ft. Lbs. (12 N.m) | ||
| 4.0L SOHC | |||
| Type | Motorcraft AGSF-24N | ||
| Gap | 0.052-0.054 In. (1.32-1.37 mm) | ||
| Torque | 133 In. Lbs. (15 N.m) | ||
| Starting | |||
| Starter | STARTER MOTOR | ||
| Torque | SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Torque | |||
| Rear Wheel Drive (RWD) | SPECIFICATIONS | ||
| Four Wheel Drive (4WD) | SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||