Driver Air Bag Module: Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking buttons.
- Align the driver air bag module locking pins to the steering wheel and, while pushing inward, seat the 2 driver air bag module locking pins to the steering wheel wire clips.
- Repower the SRS. For additional information, REFER to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in the General Procedures portion of this service information.
NOTE:
The driver air bag module electrical connector locking buttons must be in the released position when connected. Do not install the driver air bag module electrical connectors by the locking buttons. Failure to follow these instructions may cause connector damage.