Section 32 (Rear Disc Brake System): Specifications
WARNING: This page is about a different variant/trim than selected.
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| High Performance DOT 3 Motor Vehicle Brake Fluid PM-1-C (US); CPM-1-C (Canada) |
WSS-M6C62-A or WSS-M6C65-A1 | 1550-1750 ml (3.27-3.69 pt) |
| Silicone Brake Caliper Grease and Dielectric Compound XG-3-A |
ESE-M1C171-A | - |
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Brake Disc | |
| Minimum brake disc thickness (E-150, E-250, E-350) | 34.4 mm (1.354 in) |
| Minimum brake disc thickness (E-450) | 40.4 mm (1.590 in) |
| Brake Pads | |
| Maximum brake pad taper wear (in any direction) | 3.0 mm (0.118 in) |
| Minimum brake pad thickness | 1.0 mm (0.039 in) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Axle vent | 17 | - | 150 |
| Brake caliper anchor plate bolts | 225 | 166 | - |
| Brake caliper flow bolts | 40 | 30 | - |
| Brake caliper guide pin bolts | 61 | 45 | - |
| Brake caliper support bracket bolts | 175 | 129 | - |
| Brake flexible hose bracket bolt | 25 | 18 | - |
| Brake tube fitting | 18 | - | 159 |