Removal and Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
It is not necessary to remove the Audio Front Control Module (ACM) to retrieve the part number. For additional information, refer to AUDIO CONTROL MODULE (ACM) SELF-DIAGNOSTIC MODE .
- Upload the ACM configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION article.
- Remove the instrument cluster finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
- Remove the 4 screws and the ACM.
- Disconnect the electrical connectors and antenna cable(s).
- To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to MODULE CONFIGURATION article.
NOTE:
Module configuration is required when a new ACM is being installed.
NOTE:
Module configuration is not required for the Base AM/FM ACM.