Section 60 (Engine Cooling System): Specifications
WARNING: This page is about a different variant/trim than selected.
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| Motorcraft® Metal Surface Prep ZC-31-A |
- | - |
| Motorcraft® Premium Gold Engine Coolant VC-7-B (US); CVC-7-B (Canada) |
WSS-M97B51-A1 | 4.6L - 22.6L (23.8 qt) 4.6L with aux. rear heat - 24.6L (26.0 qt) 5.4L - 27.2L (28.8 qt) 5.4L with aux. rear heat - 29.1L (30.8 qt) 6.8L - 28.8L (30.4 qt) 6.8L with aux. rear heat - 30.8L (32.6 qt) |
| Motorcraft® Premium Cooling System Flush VC-1 |
ESR-M14P7-A | - |
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Pressure Tests | |
| Complete cooling system maximum pressure | Use individual readings listed on the pressure relief cap |
| Pressure relief cap | Use individual readings listed on the pressure relief cap |
| Radiator (out of vehicle) | 138 kPa (20 psi) |
| Viscous Fan Clutch Test Specification | |
| Minimum speed requirements | 1, 600 RPM |
| Maximum speed requirements | 2, 300 RPM |
| Thermostat Opening Temperature | |
| Starts to open | 86.7-90.6°C (188-195°F) |
| Fully open | 100°C (212°F) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| A/C condenser fitting nut | 8 | - | 71 |
| A/C condenser bolt | 9 | - | 80 |
| Block heater screw | 2 | - | 18 |
| Coolant pump bolts | 25 | 18 | - |
| Coolant pump pulley bolts | 25 | 18 | - |
| Cooling fan shroud bolts | 6 | - | 53 |
| Cooling fan-to-cooling fan clutch bolt | 7 | - | 62 |
| Degas bottle bolts | 6 | - | 53 |
| Fan clutch hub-to-coolant pump - 4.6L and 5.4L | 55 | 41 | - |
| Fan clutch hub-to-coolant pump - 6.8L | 133 | 98 | - |
| Power steering reservoir bracket-to-cowl bolts | 14 | - | 124 |
| Power steering reservoir bracket-to-radiator support bolts | 9 | - | 80 |
| Power steering reservoir-to-bracket bolts | 11 | - | 97 |
| Radiator mounting bracket retaining bolts | 20 | - | 177 |
| Thermostat housing bolts | 25 | 18 | - |