Component testing procedure
WARNING: This page is about a different variant/trim than selected.
COMPONENT TESTING PROCEDURE CHART
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | From C202A cavity 1 to C202A cavity 2 | Hazard switch to Normal (Off) and Turn switch to Left | Closed circuit |
| From C202A cavity 1 to C202A cavity 3 | Hazard switch to Normal (Off) and Turn switch to Right | Closed circuit | |
| Hazard | From C202A cavity 10 to C202A cavity 6 | Hazard switch to Hazard (On) (Button pushed in and then released to fully extended position) | Closed circuit |
| Flash-to-pass | From C202B cavity 11 to cavity 10 | Pull and hold lever stalk toward steering wheel | Closed circuit |
| High beam | From C202B cavity 9 to C202B cavity 10 | Lever stalk in detent away from steering wheel | Closed circuit |
| Low beam | From C202B cavity 9 to C202B cavity 10 and from C202B cavity 11 to C202B cavity 10 | Lever stalk in neutral position toward steering wheel | Open circuit |