Component testing procedure
WARNING: This page is about a different variant/trim than selected.
COMPONENT TESTING PROCEDURE CHART
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Power and Ground Checks Before Any Other Tests | 4 and 2 | Rest | Open circuit |
| 4 and all others except 2 | Rest | Closed circuit | |
| Front up/down circuit | 5 and 2 | Up | Closed circuit |
| 7 and 2 | Down | Closed circuit | |
| Rear up/down circuit | 6 and 2 | Up | Closed circuit |
| 1 and 2 | Down | Closed circuit | |
| Entire seat circuit | 3 and 2 | Rearward | Closed circuit |
| 8 and 2 | Forward | Closed circuit | |
| 1 and 2 7 and 2 |
Down | Closed circuit | |
| 5 and 2 6 and 2 |
Up | Closed circuit |