Section 75 (HVAC - Climate Control System): Specifications
WARNING: This page is about a different variant/trim than selected.
MATERIAL SPECIFICATIONS
| Item | Specification | Fill Capacity |
|---|---|---|
| Motorcraft® PAG Refrigerant Compressor Oil YN-12-D |
WSH-M1C231-B | (Vehicles without auxiliary system) 237 ml (8 fl oz) |
| Motorcraft® PAG Refrigerant Compressor Oil YN-12-D |
WSH-M1C231-B | (Vehicles with auxiliary system) 473 ml (16 fl oz) |
| Motorcraft® R-134a Refrigerant YN-19 (US); CYN-16-R (Canada) |
WSH-M17B19-A | (Vehicles without auxiliary system) 0.85 kg (30 oz) |
| Motorcraft® R-134a Refrigerant YN-19 (US); CYN-16-R (Canada) |
WSH-M17B19-A | (Vehicles with auxiliary system) 1.53 kg (54 oz) |
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| A/C Compressor Magnetic Clutch | |
| Air gap clearance | 0.35-0.65 mm (0.014-0.026 in) |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| A/C clutch disc and hub bolt | 13 | - | 115 |
| A/C compressor bolts | 25 | 18 | - |
| A/C compressor fitting nuts (suction and discharge) | 15 | - | 133 |
| A/C compressor pressure relief valve | 10 | - | 89 |
| Battery tray bolts | 28 | 21 | - |
| Compressor suction line fitting nut | 15 | - | 133 |
| Condenser bracket bolts | 12 | - | 106 |
| Condenser fitting nuts (inlet and outlet) | 15 | - | 133 |
| Condenser-to-evaporator line bracket screws | 3 | - | 27 |
| Cowl ground strap bolt | 8 | - | 71 |
| Evaporator inlet fitting | 18 | - | 159 |
| Evaporator inlet fitting bracket screw | 2 | - | 18 |
| Evaporator outlet fitting | 40 | 30 | - |
| High-pressure service gauge port valve cap | 0.8 | - | 7 |
| High-pressure Schrader-type valve | 2.5 | - | 22 |
| Low-pressure service gauge port valve cap | 0.8 | - | 7 |
| Low-pressure Schrader-type valve | 1.8 | - | 16 |
| Oil filler tube bolt | 9 | - | 80 |
| Radiator bracket bolts | 20 | - | 177 |
| Suction accumulator bolts | 12 | - | 106 |
| Suction accumulator outlet fitting nut | 15 | - | 133 |
| Suction accumulator outlet line bracket screw | 2 | - | 18 |
| Washer reservoir filler tube bolts | 9 | - | 80 |
| Wire harness stud (RH lower front of engine) | 47 | 35 | - |