Audio Systems With Touchscreen

WARNING: This page is about a different car, the 2013 Lincoln MKX and 2013 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the Audio Front Control Module (ACM) is completely inoperative (does not power up), obtain the ACM part number using the part number decal on the ACM.

Turn the ACM on.
Operate the audio system in radio tuner (AM/FM) mode.
Press and hold the EJECT button, and within 1 second, press the SEEK UP button until the speaker walk-around test begins.
- The display indicates each speaker as it is tested.

NOTE: If the speaker walk-around test is the only test required, this procedure can be stopped after Step 3 by turning the ACM off, or by selecting Exit using the touchscreen menu.

NOTE: The AHU Diagnostics refers to the ACM and EFP Diagnostics refers to the Front Controls Interface Module (FCIM).

Once the speaker walk-around test is complete, the following information is available through the "BEZEL DIAGNOSTICS" menu using the touchscreen menus:

Menu	Sub-Menu
APIM Diagnostics	Part Numbers
	Software Versions
	Configuration Status
	GPS Information
	Tones Test
	Rear Tones Test
	Touch Screen Calibration
	Touch Screen Activation Test
	Display Test Pattern
	RGB Pixel Test
	Exit Diagnostics

Menu	Sub-Menu
AHU Diagnostics	AHU Part Numbers/Sirius Electronic Serial Number (ESN)
	Radio Signal Strength
	Exit Diagnostics

Menu	Sub-Menu
DSP Diagnostics	DSP Part Numbers
	Speaker Walk-Around Test
	Exit Diagnostics

Menu	Sub-Menu
EFP Diagnostics	EFP Part Numbers
	Exit Diagnostics

To exit the self-diagnostic mode, press the "Exit Diagnostics" selection from the "BEZEL DIAGNOSTICS" menu.