LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Edge SEL, 2.0 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1875 (MULTIFUNCTION Electronic Modules) >> Removal And Installation >> Remote Function Actuator (RFA) Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Remote Function Actuator (RFA) Module: Removal

WARNING: This page is about a different car, the 2013 Lincoln MKX and 2013 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If a new Remote Function Actuator (RFA) module is installed, verify at least 2 of the vehicle keys are available prior to carrying out this procedure.
NOTE: If a new Remote Function Actuator (RFA) module is installed, the ignition does not turn on until a parameter reset is performed and 2 keys are programmed.
    NOTE: This step is only necessary if the RFA module is being replaced.
  1. Upload the module configuration information from the RFA module. For additional information, refer to MODULE CONFIGURATION .
  2. Remove the glove compartment. For additional information, refer to Instrument Panel - Exploded View in INSTRUMENT PANEL AND CONSOLE .
  3. Disconnect the RFA module electrical connectors.
  4. Remove the 2 nuts and the RFA module.
scientia non olet · About LEMON Manuals