Starting System DTCS
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| P0512 | Starter Request Circuit | CARRY OUT the Ignition Switch component test. Refer to OEM COMPONENT TESTING . If necessary, INSTALL a new ignition switch. REFER to STEERING COLUMN SWITCHES . If the ignition switch passed the component test, REPAIR circuit CDC35 (BU/WH) for a short to voltage. |
| P0706 | Transmission Range Sensor "A" Circuit Range/Performance | REFER to AUTOMATIC TRANSMISSION - 6F50/6F55 or AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 . |
| P0708 | Transmission Range Sensor "A" Circuit High | REFER to AUTOMATIC TRANSMISSION - 6F50/6F55 or AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 . |
| P161A | Incorrect Response From Immobilizer Control Module | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . |
| P1702 | Transmission Range Sensor Circuit Intermittent | REFER to AUTOMATIC TRANSMISSION - 6F50/6F55 or AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 . |
| P1705 | Transmission Range Circuit Not Indicating Park/Neutral During Self Test | REFER to AUTOMATIC TRANSMISSION - 6F50/6F55 or AUTOMATIC TRANSAXLE/TRANSMISSION - 6F35 . |
| P2532 | Ignition Switch Run Position Circuit High | GO to PINPOINT TEST G . |
| P2535 | Ignition Switch Run/Start Position Circuit High | GO to PINPOINT TEST G . |
| All other DTCs | - | REFER to ELECTRONIC ENGINE CONTROLS . |
BODY CONTROL MODULE (BCM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1305:01 | Hood Switch: General Electrical Failure | REFER to ANTI-THEFT - PERIMETER . |
| C113A:11 | Wake up Control: Circuit Short to Ground | GO to PINPOINT TEST D . |
| C113A:15 | Wake up Control: Circuit Short to Battery or Open | GO to PINPOINT TEST D . |
| U1000:00 | Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information | The Body Control Module (BCM) has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other DTCs first. After the cause of the concern is corrected, CLEAR the DTCs. REPEAT the self-test. |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES . |
TIRE PRESSURE MONITOR (TPM) MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1D55:01 | Antenna #2: General Electrical Failure | GO to PINPOINT TEST E . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES . |