LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Escape Limited, 2.5 7, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls - 2.5L (Except Hybrid) >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM cowl seal.
  2. Install the PCM and the 2 bolts.
    • Tighten to 8 Nm (71 lb-in).
  3. Connect the 3 PCM electrical connectors.
  4. Attach the wiring harness retainer to the cowl stud bolt.
    5. NOTE: If the Programmable Module Installation (PMI) procedure was not successful in downloading the data from the vehicles original PCM, then the oil life data of the vehicle is lost. If this occurs, and the oil life cannot be determined through service history or customer interview, it is recommended the vehicle engine oil and filter be changed and the oil change minder reset.
  5. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION article.
  6. Reprogram the PATS. Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article.
  7. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instrument.
scientia non olet · About LEMON Manuals