Cruise-Control Module (C-CM): Installation

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

If required, install the 3 bolts and the C-CM bracket assembly.
1. Tighten the bolts to 8 Nm (71 lb-in).
NOTE: If a plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.

Firmly apply pressure to the C-CM so that it seats completely in the grommets.
Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.
1. Connect the electrical connector.
Check the C-CM alignment. Refer to CRUISE CONTROL MODULE (C-CM) (WITH SENSOR) ADJUSTMENT .
If a new module is installed, download the module information from the scan tool to the new C-CM by following the scan tool on-screen instructions.
If a new module is installed, it must be reconfigured using PMI . MODULE CONFIGURATION SYSTEM .
Install the front bumper cover. BUMPER SYSTEM