LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Explorer Base, 2.0 9 >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Side And Rear Vision) >> Removal And Installation >> Side Obstacle Detection (SOD) Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Side Obstacle Detection (SOD) Module: Removal

WARNING: This page is about a different car, the 2013 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.

    Upload the module configuration information from the Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) into the scan tool by following the scan tool on screen instructions.

  2. Remove the rear bumper cover. REFER to BUMPER COVER - REAR .
  3. Remove the Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R).
    1. Disconnect the electrical connector.
    2. Remove the Side Obstacle Detection Control Module - Left (SOD-L) or Side Obstacle Detection Control Module - Right (SOD-R) bolt.
scientia non olet · About LEMON Manuals