| B00D5:01 |
Restraint System Passenger Disable Indicator: General Electrical Failure |
CLEAR the DTCs
. WAIT 10 seconds. REPEAT the self-test. If DTC
B00D5:01 is still present, INSTALL a new FCIM
. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM)
. |
| B113C:11 |
Hazard Switch Illumination: Circuit Short To Ground |
CLEAR the DTCs
. WAIT 10 seconds. REPEAT the self-test. If DTC
B113C:11 is still present, INSTALL a new FCIM
. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM)
. |
| B1202:01 |
Restraint System Passenger Enable Indicator: General Electrical Failure |
CLEAR the DTCs
. WAIT 10 seconds. REPEAT the self-test. If DTC
B1202:01 is still present, INSTALL a new FCIM
. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM)
. |
| U0155:00 |
Lost Communication With IPC
Module: No Sub Type Information |
GO to PINPOINT TEST AA. |
| U0423:00 |
Invalid Data Received From Instrument Panel Cluster Control Module: No Sub Type Information |
REFER to
INFORMATION CENTER - INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES
to RETRIEVE and FOLLOW DTCs
present in the IPC
. |
| U2013:63 |
Switch Pack: Circuit / Component Protection Time-Out |
GO to PINPOINT TEST U. |
| U201A:51 |
Control Module Main Calibration Data: Not Programmed |
DTC
U201A:51 sets when the FCIM
calibration is missing or corrupted. The INSTALL a new FCIM
. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM)
. |
| U3000:41 |
Control Module: General Checksum Failure |
CLEAR the DTCs
. WAIT 10 seconds. REPEAT the self-test. If DTC
U3000:41 is still present, INSTALL a new FCIM
. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM)
. |
| U3000:42 |
Control Module: General Memory Failure |
CLEAR the DTCs
. WAIT 10 seconds. REPEAT the self-test. If DTC
U3000:42 is still present, INSTALL a new FCIM
. REFER to FRONT CONTROLS INTERFACE MODULE (FCIM)
. |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to PINPOINT TEST AF. |
| U3003:17 |
Battery Voltage: Circuit Voltage Above Threshold |
GO to PINPOINT TEST AG. |