Tool Link(TM) Reader

Tool Link(TM) Reader









Removal and Installation

1. Pull back the carpet from the LH side of the passenger compartment rear interior wall.

2. NOTE: Support the Tool Link(TM) reader while the 2 screws are being removed. Do not allow it to hang from the electrical connectors.
Remove the 2 screws and the Tool Link(TM) reader.

- Disconnect the electrical connectors.

- If the Tool Link(TM) reader is being replaced, cut the power/ground feed from the vehicle electrical harness.


3. To install, reverse the removal procedure.
- If a new Tool Link(TM) is being installed, splice the new power/ground feed to the vehicle electrical harness.