Head Rest: Service and Repair

Head Restraint Guide Sleeve

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Special Tool(s)

General Equipment:






Removal

1.





2. General Equipment: Screwdriver





Installation

1. NOTE: Make sure the holes in the backrest cover and backrest foam pad are aligned to the holes in the backrest frame.






2. By hand, pull upward on the head restraint guide sleeves and make sure they are properly locked into the backrest frame holes. If either of the head restraint guide sleeves can be removed by hand, repeat the installation procedure. If the head restraint guide sleeve(s) can be removed again after installing a second time, install a new head restraint guide sleeve(s).

3.