Removal and Installation
WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
All vehicles
- Upload the ACM configuration to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
- Remove the middle instrument panel center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Remove the 4 ACM
screws.
- To install, tighten to 2 Nm (18 lb-in) (navigation).
- To install, tighten to 1 Nm (9 lb-in) (all except navigation).
Navigation
- Disconnect the antenna and electrical connectors.
All except navigation
- Remove the 2 ACM
brackets.
All vehicles
- Remove the ACM .
- To install, reverse the removal procedure.
- Download the configuration information to the ACM . For additional information, refer to PMI in MODULE CONFIGURATION .
NOTE:
Module configuration is only required if a new ACM
is being installed.
NOTE:
Only carry out this step if installing a new ACM
.