LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1428 (Electronic Power Assist Steering Component Testing) >> Pin Point Tests >> Pin Point Test S: Steering Column Mounted EPAS - Steering System Pull, Drift, Wander or Steering Wheel is Off Center
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pin Point Test S: Steering Column Mounted EPAS - Steering System Pull, Drift, Wander or Steering Wheel is Off Center

WARNING: This page is about a different car, the 2017 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This pinpoint test is intended to diagnose vehicles with steering column mounted EPAS systems only. Do not use this pinpoint test to diagnose vehicles with steering gear mounted EPAS systems.
  1. S1: ISOLATE THE EPAS COLUMN ASSEMBLY 
    • Ignition OFF.
    • PSCM_A connector disconnected. (C1463A)
    • PSCM_B connector disconnected. (C1463B)
    • PSCM_C connector disconnected.
    • Test drive the vehicle and verify the pull, drift and/or wander.
    • Does the vehicle pull, drift or wander? 
      Yes No
      GO to  S2. GO to  S3.
  2. S2: CHECK THE STEERING AND SUSPENSION FOR BENT OR DAMAGED COMPONENTS 
    • Check for even tire sizes and pressures.
    • Check the steering gear for loose fasteners, worn or damaged bushings.
    • Check the steering and suspension for bent or damaged components.
    • Using hand force only, check the inner and outer tie rods for vertical and lateral movement in the tie-rod ball studs and sockets.
    • Verify that the steering column shaft rotates freely and is not grounded against other vehicle components.
    • Has a concern been identified? 
      Yes No
      REPAIR or INSTALL new component(s) as necessary.
      CARRY OUT the steering angle sensor calibration procedure.
      REFER to PROGRAMMABLE PARAMETERS/STEERING WHEEL POSITION SENSOR CALIBRATION on the scan tool and follow the calibration procedure.
      DRIVE the vehicle to VERIFY the repair.      		 Refer to Suspension System - General Information to diagnose suspension system drift/pull/wander.
  3. S3: CALIBRATE THE STEERING ANGLE SENSOR 
    • Ignition OFF.
    • PSCM_A connector connected. (C1463A)
    • PSCM_B connector connected. (C1463B)
    • PSCM_C connector connected.
    • Ignition ON, engine OFF.
    • Turn the steering wheel approximately thirty degrees in each direction, then return to the central position. Make sure that the steering wheel is set to the straight ahead position.
    • With the vehicle stationary run the steering angle sensor calibration procedure.
      • REFER to PROGRAMMABLE PARAMETERS/STEERING WHEEL POSITION SENSOR CALIBRATION on the scan tool and follow the calibration procedure.
    • Test drive the vehicle.
    • Is the pull, drift, wander or steering wheel off center concern still present? 
      Yes No
      CHECK and ADJUST the front and rear toe as necessary.
      CARRY OUT the steering angle sensor calibration procedure.
      REFER to PROGRAMMABLE PARAMETERS/STEERING WHEEL POSITION SENSOR CALIBRATION on the scan tool and follow the calibration procedure.      		 The customers concern has been corrected.
scientia non olet · About LEMON Manuals