Removal And Installation

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: On the first press of the seat control switch after the seat is repaired and a new system component has been installed, the PFSM moves the seat to the home position (seat folded and latched to the floor) before continuing to move to the selected seat position. This allows the PFSM to relearn the position of the affected motors.

1.

Remove the third row seat. For additional information, refer to Seat - Third Row in this service information.

2.

Pry to release the clips and remove the LH and RH outboard pivot covers.

3.

From the RH load floor flapper panel, detach the 2 wire harness retainers and disconnect the 2 electrical connectors. Position the wire harness out of the way.

Courtesy of FORD MOTOR COMPANY

4.

From the LH load floor flapper panel, disconnect the main feed electrical connector.

5.

Remove the 4 load floor panel screws on each side at the back of the cushions.

6.

Pull out to release the retainers and remove the 2 load floor panels.

7.

Release all cushion cover retainers from the cushion frame
- On assembly, the lower anchors and tethers for children and child safety seat tether anchor must be accessible through the cushion cover.

Courtesy of FORD MOTOR COMPANY

8.

Remove the 8 cushion frame-to-pivot tube assembly bolts. Remove the pivot tube assembly with stow motors.
- To install, tighten to 60 Nm (44 lb-ft).

9.

To install, reverse the removal procedure.