Removal and Installation
WARNING: This page is about a different car, the 2013 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Prior to replacement of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new module after installation. For additional information, refer to
MODULE CONFIGURATION
.
-
NOTE: This step is necessary only if the GPSM is being replaced. Upload the module configuration information from the GPSM into the scan tool. For additional information, refer to MODULE CONFIGURATION .
- Lower the glove compartment door completely.
-
NOTE: The GPSM can be accessed through the glove compartment opening.
Disconnect the GPSM electrical connector.
- Remove the GPSM by pushing back on the locking tab.
- To install, reverse the removal procedure.
- If a new GPSM is being installed, carry out the PMI for the GPSM. For additional information, refer to MODULE CONFIGURATION .