Cruise-Control Module (C-CM): Installation
WARNING: This page is about a different car, the 2015 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.
Bracket
- 1.
Install the 3 bolts and the C-CM bracket. Tighten the fasteners in the sequence shown.- Tighten the bolts to 8 Nm (71 lb-in).
C-CM or bracket
NOTE:
The vertical and horizontal alignment procedures need to be carried out to align the sensor.
- 2.NOTE: If one plastic grommet breaks while the C-CM is being installed, a new grommet should be installed.
Firmly apply pressure to the C-CM so that it seats completely in the grommets.
- 3.
Once the C-CM is installed, pull the C-CM to confirm that all 3 ball studs are fully seated in the grommets.
- 5.
Do not install the front bumper cover until the alignment procedures are carried out.- Vertically and horizontally align the C-CM. For additional information, refer to Cruise Control Module (C-CM) (with Sensor) Adjustment .