LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 909 (Instrument Panel And Console) >> Removal And Installation >> Compressor Driver Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Compressor Driver Module

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For information on Ford Color Coded Illustrations refer to COLOR-CODING - FORD .

  1. 1.

    Remove the rear floor console refrigerator. Refer to Refrigerator .

  1. 2.

    NOTE: Do not bend the condenser tubes. The screwdriver must fit between the condenser tubes or damage may occur to the refrigerator.

    Using a long thin screwdriver, remove the Phillips screw from the compressor driver module mounting bracket.

GFD95794Courtesy of FORD MOTOR COMPANY

  1. 3.

    Disconnect the upper electrical connector from the compressor driver module.
GFD95795Courtesy of FORD MOTOR COMPANY

  1. 4.

    Rotate the compressor driver module to the right and remove from the mounting bracket.
GFD95796Courtesy of FORD MOTOR COMPANY

  1. 5.

    Disconnect the lower electrical connector from the compressor driver module.
GFD95797Courtesy of FORD MOTOR COMPANY

  1. 6.

    Disconnect the compressor driver module-to-refrigerator electrical connector.
GFD95798Courtesy of FORD MOTOR COMPANY

  1. 7.

    To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals