Clear MyKey™
- Insert an admin key into the ignition lock cylinder and turn the key to the RUN position.
- Press SETUP until PRESS RESET TO CLEAR MYKEY appears.
- Press and release the RESET button until HOLD RESET TO CONFIRM CLEAR.
- Press and hold the RESET button until ALL MYKEYS CLEARED is displayed.
- A MyKey™ can also be cleared during the same key cycle that it was programmed by following Steps 2, 3 and 4 of this procedure.
NOTE:
This procedure is used to clear the MyKey™ feature on all of the keys that are programmed to the vehicle. All of the keys then operate as normal (admin) keys with no restrictions.