Pinpoint Test E: The Flash-To-Pass Feature Is Inoperative

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

E1 VERIFY THE HIGH BEAM HEADLAMP OPERATION
- Ignition ON.
- Place the headlamp switch in the HEADLAMPS ON position and activate the high beams.
Do the high beam headlamps illuminate?
- Yes : INSTALL a new multifunction switch. REFER to STEERING COLUMN SWITCHES . TEST the system for normal operation.
  If the concern still exists, INSTALL a new SCCM . REFER to STEERING COLUMN SWITCHES . TEST the system for normal operation.
- No : GO to PINPOINT TEST B .