LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Mustang Base, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 741 (Front Seats System) >> Diagnosis And Testing >> Front Seats >> DTC Chart: SCMH
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Chart: SCMH

WARNING: This page is about a different car, the 2015 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

SCMH DTC Chart 

DTC Description Action
B146F:00 Back Bladder System Electropneumatic Failure: No Sub Type Information GO to Pinpoint Test AM 
B146F:04 Back Bladder System Electropneumatic Failure: System Internal Failure GO to Pinpoint Test AM 
B1470:00 Cushion Bladder System Electropneumatic Failure: No Sub Type Information GO to Pinpoint Test AM 
B1470:04 Cushion Bladder System Electropneumatic Failure: System Internal Failure GO to Pinpoint Test AM 
B1471:11 Multi-Contour Seat Switch Input: Circuit Short To Ground GO to Pinpoint Test AM 
B1471:13 Multi-Contour Seat Switch Input: Circuit Open GO to Pinpoint Test AM 
B1471:2A Multi-Contour Seat Switch Input: Signal Stuck In Range VERIFY there is no obstruction that may be causing the multi-contour seat switch to be stuck in a certain position. If OK, INSTALL a new seat control switch. REFER to: Front Seat Control Switch .
B1473:11 Pump Driver: Circuit Short To Ground GO to Pinpoint Test AM 
U1000:00 Solid State Driver Protection Activated - Driver Disabled: No Sub Type Information DIAGNOSE any other related SCMH Diagnostic Trouble Codes (DTCs) first. CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If DTC U1000:00 returns. INSTALL a new SCMH. REFER to: Driver Multi-Contour Seat Module [SCMG] .
U2100:00 Initial Configuration Not Complete: no Sub Type Information
NOTE: This DTC indicates PMI has not been done to a newly installed module or configuration data has been lost.
Using a diagnostic scan tool, CARRY OUT PMI on the SCMH. REPEAT the self-test and VERIFY successful PMI. CLEAR the Diagnostic Trouble Codes (DTCs).
U3000:49 Control Module: Internal Electronic Failure INSTALL a new SCMH. REFER to: Driver Multi-Contour Seat Module [SCMG] .