Torca® Clamp

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Remove the nut from the Torca® clamp.
Grind the spot weld from the Torca® clamp and remove the clamp.
Clean the uneven surface area and position a new Torca® clamp.

Fig 1: Locating Uneven Surface Area

Courtesy of FORD MOTOR CO.

Make sure the button is fully seated inside the notch.

Fig 2: Making Sure Button Is Fully Seated Inside Notch

Courtesy of FORD MOTOR CO.

NOTE: Do not tighten the clamp until the exhaust system has been aligned.

Tighten the new Torca® clamp.
- Tighten to 47 Nm (35 lb-ft).