Occupant Classification Module - Manual Seat Track: Removal
WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
CAUTION:
Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result in damaged components.
NOTE:
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
- Disconnect the occupant classification sensor (OCS) module electrical connector.
- Remove the 2 screws and the OCS module.
- To install, reverse the removal procedure.
- Install the passenger seat and repower the SRS. Do not prove out the SRS at this time. For additional information, refer to SEATING .
- Carry out the appropriate procedure after installation of an OCS system component.
- If installing the original OCS system component, carry out the Zero Seat Weight Test and prove out the SRS. For additional information, refer to Occupant Classification Sensor (OCS) System Zero Seat Weight Test .
- If installing a new OCS system component, carry out the System Reset procedure and prove out the SRS. For additional information, refer to Occupant Classification Sensor (OCS) System Reset .