LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Taurus SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 1347 (Electronically Controlled Continuously Variable Transmission (ECVT)) >> In-Vehicle Repair >> Transmission Range (TR) Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmission Range (TR) Sensor: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position TR  sensor on the manual shaft, align the 2 TR  sensor bolt holes and install the 2 bolts.
    • Tighten to 5 Nm (44 lb-in).
    Fig 1: Locating TR Sensor Bolts
    G06275507Courtesy of FORD MOTOR CO.
  2. Install the manual control lever and the nut.
    • Tighten to 12 Nm (106 lb-in).
    Fig 2: Locating Manual Control Lever & Nut
    G06275509Courtesy of FORD MOTOR CO.
  3. Connect the TR  sensor electrical connector.
    Fig 3: Locating TR Sensor Electrical Connector
    G06275510Courtesy of FORD MOTOR CO.
  4. Adjust the selector lever cable. For additional information, refer to SELECTOR LEVER CABLE ADJUSTMENT . Connect the selector lever cable end.
    Fig 4: Locating Selector Lever Cable
    G06275511Courtesy of FORD MOTOR CO.
  5. Install the underbody cover and 7 screws.
    Fig 5: Locating Underbody Cover Screws
    G06257240Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals