Driver Air Bag Module: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The driver air bag module electrical connector locking buttons must be in the released position when connected. Do not install the driver air bag module electrical connectors by the locking buttons. Failure to follow these instructions may cause connector damage.

With the locking buttons released, install the driver air bag module electrical connectors fully into the driver air bag module and seat the locking buttons.

Fig 1: Locating Driver Air Bag Module Electrical Connectors
Courtesy of FORD MOTOR CO.
Align the driver air bag module locking pins to the steering wheel and, while pushing inward, seat the 2 driver air bag module locking pins to the steering wheel wire clips.
Repower the SRS . For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING .