Removal and Installation
WARNING: This page is about a different car, the 2012 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Upload the FDIM configuration information to the scan tool. For additional information, refer to MODULE CONFIGURATION SYSTEM to carry out Programmable Module Installation (PMI).
- Remove the center instrument panel finish panel. For additional information, refer to the INSTRUMENT PANEL AND CONSOLE .
- Remove the 4 screws and the FDIM.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.
- Download the configuration information to the FDIM. For additional information, refer to MODULE CONFIGURATION SYSTEM to carry out PMI.
NOTE:
Module configuration is required when a new Front Display Interface Module (FDIM) is being installed.