Body Control Module (BCM): Installation

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Install the 2 bolts and the BCM.
- Tighten to 2 Nm (18 lb-in).
Install the in-line connector push-pin on the BCM.
Connect the 7 BCM electrical connectors.
NOTE: If the BCM was not replaced, this is the last step that is necessary.

Install the passenger cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
NOTE: Once the BCM Programmable Module Installation (PMI) is complete, follow the scan tool's on-screen instructions for performing the Configurable Engine Immobilizer (CEI) Lock Configuration.

Download the BCM configuration information from the scan tool. For additional information, refer to MODULE CONFIGURATION SYSTEM .
NOTE: If a new BCM is installed, the BCM and the PCM require a parameter reset to allow the BCM and the PCM to recognize each other.

NOTE: If equipped, the vehicle's IKTs must be programmed to the new BCM.

If installing a new BCM, carry out the parameter reset and key programming procedure. For additional information, refer to ANTI-THEFT SYSTEM - PASSIVE ANTI-THEFT SYSTEM (PATS) .
Carry out the BCM on-demand self-test to confirm all DTCs have been cleared.