Remote Start

WARNING: This page is about a different car, the 2013 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

The factory remote start system (if equipped) does not operate if the ignition is in the RUN/START position or the hood is not closed.

The remote start system can be enabled or disabled by the customer. When enabled, the customer can set the engine run time for 5, 10 or 15 minutes. For information on setting the engine run time, refer to the Owner's Literature or INFORMATION CENTER - INSTRUMENTATION, MESSAGE CENTER, AND WARNING CHIMES .

The remote start system enables the engine to be started from up to 100 m (328 ft) away, by pressing a sequence of buttons on the Integrated Keyhead Transmitter (IKT). The remote start system is activated by pressing the lock button on the IKT, to make sure the doors are locked, followed by 2 presses of the remote start button. The 3 button presses must occur within 3 seconds. The system acknowledges the start request by flashing the exterior lights twice. Once started, the engine runs for 10 minutes (default run time is 10 minutes; the time can be programmed by the customer to 5, 10 or 15 minutes) and the parking lights remain illuminated until the cycle is complete. The remote start duration can also be extended by initiating remote start while the first timer is still running or by initiating a completely independent start cycle when the first has completed. No more than 2 remote start sequences can occur within a one hour period, unless the ignition is set to the RUN/START position between the remote start requests. During the remote start cycle the power windows are inhibited and the radio will not turn on automatically but may be switched on manually from inside the vehicle. If the remote start system fails to start the horn chirps twice.

To transition from remote start mode to drive mode, use a programmed IKT to switch the ignition to the RUN position. If a programmed IKT is not used, the engine shuts off.

To deactivate the remote start system, press the remote start button once. When deactivating the remote start system the parking lights turn off to give a visual indication that the engine and climate control features have turned off. It may be necessary to be closer to the vehicle to deactivate the remote start feature than it was to initiate it due to ground deflections and added noise from the engine running.

The remote start system conditions the cabin temperature during remote start based on the outside temperature. For information on cabin temperature conditioning during remote start, refer to HVAC - CLIMATE CONTROL SYSTEM (GENERAL INFORMATION & ELECTRICAL DIAGNOSTICS) .