LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Taurus SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 2517 (Electronic Engine Controls) >> Removal And Installation >> Powertrain Control Module (PCM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Removal

WARNING: This page is about a different car, the 2014 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

All engines 

  1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .

    Vehicles equipped with a 3.5L Gasoline Turbocharged Direct Injection (GTDI) engine 

  2. Disconnect the 2 Powertrain Control Module (PCM) electrical connectors.
  3. Disengage and remove the PCM  cover.
  4. Remove the 2 PCM  -to-PCM  support bracket bolts and the PCM  .
  5. If the PCM  support bracket is damaged, remove the nut and position the ground cable aside and remove the 2 PCM  stud bolts and slide the PCM  support bracket out of the bulkhead.

    Vehicles equipped with a 3.7L, 5.0L (4V) or 6.2L (2V) engine 

  6. Disconnect the Powertrain Control Module (PCM) electrical connectors.
  7. Remove the stud bolts, the PCM  and the gasket.
scientia non olet · About LEMON Manuals