Horizontal Alignment

WARNING: This page is about a different car, the 2016 Lincoln MKS. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The horizontal alignment for the cruise control sensor is a software calibration. No manual adjustment is needed for this procedure. The scan tool calibrates the C-CM radar sensor unit through the C-CM calibration procedure.

1.

NOTE: The engine must be running during the horizontal alignment procedure. Failure to leave the engine running throughout the entire procedure results in the cancellation of the alignment procedure and the system remains non-functional.

Start the engine.

2.

Follow the scan tool on-screen instructions to carry-out the C-CM calibration procedure.
- Follow the scan tool on-screen instructions to carry-out the CCM calibration procedure located in IDS under Toolbox > Electrical > Cruise Control > CCM Calibration.
- After completion of the test, verify that the test completed successfully.
- Follow the prompts to drive the vehicle after successful completion of the test. This may take several minutes.