Removal And Installation

WARNING: This page is about a different car, the 2015 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

1.

NOTE: This step is necessary only if the Driver Seat Module (DSM) is being replaced.

NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the scan tool. This information must be downloaded into the new module after installation. For additional information, refer to Module Configuration .

Upload the module configuration information from the DSM. For additional information, refer to Module Configuration .

2.

Position the seat to the highest and most-rearward position to increase the ease-of-access to the DSM.

3.

Disconnect the DSM electrical connectors.

4.

Remove the 2 bolts and the DSM.

5.

NOTE: If installing a new DSM, make certain to download the module configuration information to the new module after installation.

To install, reverse the removal procedure.